Edexcel GCSE Biology
Photosynthesis
Total 27 marks
Name
Class
Date
- 1A student places a sprig of pondweed in a beaker of water under a bright lamp. Bubbles of gas begin to stream from the cut end of the stem. The student collects the gas in an upturned test tube and, after several minutes, tests it with a glowing splint. The splint relights when inserted into the tube.(a)Which gas is used by the pondweed as a raw material for photosynthesis?[1 mark]
- AOxygen
- BCarbon dioxide
- CNitrogen
- DHydrogen
Show the mark scheme
Mark scheme
Answer: B(b)Which result of the glowing splint test confirms the identity of the gas collected?[1 mark]- AThe splint is extinguished immediately
- BThe splint turns limewater cloudy
- CThe splint produces a squeaky pop
- DThe splint relights and burns brightly
Show the mark scheme
Mark scheme
Answer: D(c)Write the word equation for the reaction taking place in the pondweed and explain why this reaction is described as endothermic.[2 marks]Show the mark scheme
Mark scheme
[1] carbon dioxide + water → glucose + oxygen
Do not accept: oxygen on the left; light shown as a reactant without the other reactants
[1] endothermic because it takes in energy (light) from the surroundings
Accept: energy transferred from the lamp to the plantTotal for question 1: 4 marks
- 2A class investigates the effect of light intensity on the rate of photosynthesis using pondweed. Three identical beakers of pondweed in water containing dissolved sodium hydrogencarbonate are set up, each at a different distance from an identical lamp: 10 cm, 30 cm and 50 cm. Temperature is kept constant using a water bath, and the number of bubbles released per minute is counted for each beaker.(a)In the third beaker, which factor is limiting the rate of photosynthesis?[1 mark]
- ALight intensity
- BCarbon dioxide concentration
- CTemperature
- DWater availability
Show the mark scheme
Mark scheme
Answer: A(b)Why is sodium hydrogencarbonate dissolved in the water in each beaker?[1 mark]- ATo keep the water at a constant temperature
- BTo provide a constant supply of oxygen
- CTo provide a constant supply of carbon dioxide
- DTo kill any microorganisms in the water
Show the mark scheme
Mark scheme
Answer: C(c)The beaker at 10 cm produced far more bubbles per minute than the beaker at 50 cm. Explain this difference in terms of light intensity and the rate of photosynthesis.[2 marks]Show the mark scheme
Mark scheme
[1] light intensity is higher at 10 cm, because it falls as distance from the lamp increases
[1] light is a limiting factor, so the rate of photosynthesis is faster, producing more oxygen and more bubbles per minute
Do not accept: light intensity is higher with no link to the rateTotal for question 2: 4 marks
- 3A research group grows identical pondweed samples at three fixed temperatures: 10°C, 20°C and 30°C. At each temperature, they measure the rate of photosynthesis while gradually increasing light intensity, keeping carbon dioxide concentration constant throughout. At all three temperatures, the rate of photosynthesis increases with light intensity at first, then levels off at a plateau. The plateau is reached at a lower light intensity for the 10°C samples than for the 20°C or 30°C samples.(a)Describe how the researchers could use this data to determine whether light intensity or carbon dioxide concentration is the limiting factor at each temperature.[3 marks]
Show the mark scheme
Mark scheme
[1] a plateau in the rate while light intensity increases shows that another factor is now limiting
[1] to test carbon dioxide, increase its concentration with light and temperature constant; if the rate rises, carbon dioxide was limiting
[1] if the rate does not rise, increase the temperature; if the rate rises then, temperature was limiting
Accept: the factor that is limiting is the one that when increased raises the rate(b)Explain why the plateau is reached at a lower light intensity for the 10°C samples than for the 30°C samples, and suggest what would happen to the rate of photosynthesis if the temperature were increased further to 45°C.[4 marks]Show the mark scheme
Mark scheme
[1] at 10°C the enzymes of photosynthesis work more slowly because it is below their optimum
[1] so temperature becomes limiting at a lower light intensity, so the plateau is reached sooner
[1] at 30°C the enzymes work faster, so the rate keeps increasing with light intensity for longer before another factor limits it
[1] at 45°C the rate would fall because the enzymes denature, as the active site changes shape
Do not accept: enzymes are killedTotal for question 3: 7 marks
- 4A commercial greenhouse grower cultivates tomato plants year-round. During winter, natural daylight is weak and the outside temperature is low, while the greenhouse remains largely sealed to conserve heat. The grower is considering installing supplementary lighting, a heating system, and a carbon dioxide enrichment system, but has a limited budget and can only afford to install one of these systems this winter.(a)A greenhouse grower wants to maximise the rate of photosynthesis, and therefore biomass production, of tomato plants during winter, when natural light is weak and cold. Explain how each of temperature, light intensity and carbon dioxide concentration could be acting as limiting factors on photosynthesis in this greenhouse in winter, and how the interaction of these three factors together determines the overall rate.[6 marks]
Show the mark scheme
Mark scheme
[1] low light intensity in winter limits photosynthesis because less light energy is available
[1] low temperature limits it because enzymes work more slowly below their optimum
[1] carbon dioxide in a sealed greenhouse may run low, and it is a raw material, so it can limit the rate
[1] the rate is set by whichever factor is most limiting at that time
[1] improving only one factor, such as more light, has little effect if another factor is the one limiting
[1] so the grower must consider all three together to raise photosynthesis and biomass production(b)Using the inverse square law, explain how doubling the distance between a supplementary lamp and the tomato plants would affect the light intensity reaching the plants and hence the rate of photosynthesis, and evaluate whether installing supplementary lighting alone is the grower's best choice given the limited budget.[6 marks]Show the mark scheme
Mark scheme
[1] inverse square law: light intensity is proportional to 1 ÷ distance²
[1] doubling the distance reduces the light intensity to one quarter
[1] while light is limiting, the rate of photosynthesis falls in proportion, so plants far from the lamp photosynthesise much more slowly
[1] so lamp position matters, as a small increase in distance greatly reduces the benefit
[1] lighting alone may not be the best choice, as if temperature or carbon dioxide is limiting, extra light will not raise the rate
[1] judgement: the grower should find which factor is most limiting before spending the budgetTotal for question 4: 12 marks
End of questions