Rounding and Estimation Flashcards
Studying this course? Keep your progress in one place.

Flip each card. Be honest: the ones you mark Not yet come back first.
15 cards
Tap a card to flip it. Swipe right if you knew it, left if not.
See all 15 cards
- What does it mean to round a number to a given number of decimal places?
- To round to a given number of decimal places means to express the number with only that many digits after the decimal point. Look at the digit after your target decimal place: if it is 5 or above, round up; if it is below 5, round down.
- Explain the process of rounding a number to a given number of significant figures.
- Count from the first non-zero digit to identify which digit is the last significant figure needed. Look at the digit after it: if 5 or above, round the last significant figure up; if below 5, leave it unchanged. Replace all digits after this with zeros (keeping place value).
- How do you estimate an answer to a calculation by rounding to one significant figure?
- Round each number in the calculation to one significant figure, then perform the calculation using these rounded values. This gives a quick approximate answer without a calculator.
- Define the error interval for a rounded or truncated number.
- The error interval is the range of possible original values that would round or truncate to the given number. It is expressed using inequality notation, with the minimum value (inclusive) less than or equal to the original value, and the original value less than the maximum value (exclusive).
- Write the error interval in inequality notation for the value 6.5, rounded to one decimal place.
- 6.45 ≤ x < 6.55, where x is the original unrounded value.
- What is the upper bound for a measurement?
- The upper bound is the largest possible value that the original measurement could be, given the degree of accuracy to which it was rounded or truncated.
- What is the lower bound for a measurement?
- The lower bound is the smallest possible value that the original measurement could be, given the degree of accuracy to which it was rounded or truncated.
- A length is measured as 15 cm to the nearest centimetre. State the upper and lower bounds.
- Lower bound: 14.5 cm, Upper bound: 15.5 cm. These represent the range of values that would round to 15 cm.
- Explain how to find the upper bound when adding two measurements given to a degree of accuracy.
- Add the upper bounds of both measurements together. The upper bound of the sum equals the sum of the individual upper bounds.
- Explain how to find the lower bound when subtracting two measurements given to a degree of accuracy.
- Subtract the upper bound of the second measurement from the lower bound of the first measurement. This gives the smallest possible result.
- A rectangular field has length 120 m and width 85 m, both measured to the nearest metre. Calculate the upper bound for the area.
- Upper bound for length: 120.5 m, Upper bound for width: 85.5 m. Upper bound for area = 120.5 × 85.5 = 10,302.75 m².
- What is the difference between rounding and truncation?
- Rounding adjusts the last digit based on the following digit (round up if 5 or above, round down if below 5). Truncation simply cuts off all digits after a certain point without rounding.
- A number is truncated to 3.7. What is the error interval in inequality notation?
- 3.7 ≤ x < 3.8, where x is the original untruncated value.
- How should you round 4.857 to 2 decimal places?
- 4.86. The third decimal place is 7 (which is 5 or above), so round the second decimal place up from 5 to 6.
- Round 0.006748 to 2 significant figures.
- 0.0067. The first two significant figures are 6 and 7 (leading zeros are not significant). The digit after 7 is 4 (below 5), so do not round up.