Investigating Rate of Reactions

Investigating Rate of Reactions Flashcards

Spec 3.8.1 · Oxford AQA IGCSE Chemistry: Flashcards

Studying this course? Keep your progress in one place.

Flip each card. Be honest: the ones you mark Not yet come back first.

12 cards

Tap a card to flip it. Swipe right if you knew it, left if not.

See all 12 cards
What does this required practical investigate?
How a factor such as temperature, concentration, surface area or a catalyst affects the rate of a chemical reaction.
Name two methods for measuring the rate of a gas-producing reaction.
Measuring mass loss on a balance over time, or collecting and measuring gas volume over time.
What is the 'disappearing cross' method used for?
Measuring the rate of a reaction that produces a cloudy precipitate, by timing how long a mark under the flask takes to become obscured.
Why must variables other than the one being tested be kept constant?
To make the investigation a fair test, so any change in rate can be attributed to the one factor being changed.
Define independent variable.
The factor that is deliberately changed in an experiment.
What is recorded at regular time intervals in the mass-loss method?
The total mass of the reaction flask and its contents, as gas escapes and mass decreases.
How can the volume of gas produced be measured?
Using a gas syringe, or by collecting the gas by displacement of water into an inverted measuring cylinder.
Why should an experiment be repeated?
To check the results are reproducible and to allow a mean to be calculated, improving reliability.
What is an anomalous result?
A result that does not fit the general pattern of the other data and may need to be checked or repeated.
What safety precaution is commonly needed when using acids in this practical?
Wearing eye protection and working in a well-ventilated area.
What is plotted on the graph axes for a typical rate investigation?
Time on the x-axis; mass lost or gas volume produced on the y-axis.
What is a limitation of the disappearing cross method?
It only measures the time to reach one fixed point of cloudiness, not a continuous rate throughout the reaction.

Flashcards