Production of Sulfuric Acid Flashcards
Studying this course? Keep your progress in one place.

Flip each card. Be honest: the ones you mark Not yet come back first.
14 cards
Tap a card to flip it. Swipe right if you knew it, left if not.
See all 14 cards
- What is the Contact process used to manufacture?
- Sulfuric acid (H2SO4)
- How many stages does the Contact process have?
- Three
- Write the equation for Stage 1 of the Contact process.
- S(s) + O2(g) → SO2(g)
- Write the equation for Stage 2 of the Contact process.
- 2SO2(g) + O2(g) ⇌ 2SO3(g)
- Write the equation for Stage 3 of the Contact process.
- H2O(l) + SO3(g) → H2SO4(aq)
- Which stage of the Contact process is reversible?
- Stage 2 only
- What catalyst is used in Stage 2?
- Vanadium(V) oxide
- What temperature is used in Stage 2?
- Approximately 450 °C
- What pressure is used in Stage 2?
- Atmospheric pressure
- Why is atmospheric pressure used in Stage 2 rather than a higher pressure?
- The yield is already very high (about 98%) at atmospheric pressure, so using higher pressure would add cost for little extra benefit
- Why is 450 °C used rather than a lower temperature in Stage 2?
- A lower temperature would give a higher yield (the forward reaction is exothermic) but the rate would be too slow; 450 °C is a compromise between rate and yield
- What does the vanadium(V) oxide catalyst do?
- It increases the rate of Stage 2 without being used up itself
- What is produced in Stage 1 of the Contact process?
- Sulfur dioxide (SO2)
- What is produced in Stage 3 of the Contact process?
- Sulfuric acid (H2SO4)