Centre of Gravity

Centre of Gravity Flashcards

Spec 1.5.3 · Cambridge IGCSE Physics: Flashcards

Studying this course? Keep your progress in one place.

Flip each card. Be honest: the ones you mark Not yet come back first.

13 cards

Tap a card to flip it. Swipe right if you knew it, left if not.

See all 13 cards
What is meant by the centre of gravity of an object?
The point through which the whole weight of the object may be considered to act.
Where is the centre of gravity of a regular, uniform object?
At its geometric centre.
What equipment is used to find the centre of gravity of an irregular lamina?
A pin to hang the lamina freely, and a plumb line (thread with a weight) to mark the vertical.
How many suspension points are needed to find the centre of gravity of an irregular lamina experimentally, and why?
At least two, because a single plumb-line trial only shows a line the centre of gravity lies on; the crossing point of two lines gives the exact position.
Why does the plumb line method work?
When a lamina hangs freely from a pivot, its centre of gravity always comes to rest directly below the pivot, so the plumb line marks that vertical line each time.
What two conditions define equilibrium?
No resultant force and no resultant moment acting on the object.
State the principle of moments.
For an object in equilibrium, the sum of the clockwise moments about a pivot equals the sum of the anticlockwise moments.
Does the principle of moments still apply if there is more than one force on each side of the pivot?
Yes — add up all the clockwise moments and all the anticlockwise moments separately, then compare the two totals.
Describe an experiment to show there is no resultant moment on a balanced object.
Balance a metre rule on a pivot with known weights hung at measured distances on each side; when it is horizontal and stationary, the sum of clockwise moments equals the sum of anticlockwise moments.
How does the height of the centre of gravity affect stability?
A lower centre of gravity makes an object more stable; a higher centre of gravity makes it less stable.
How does the width of the base affect stability?
A wider base makes an object more stable; a narrower base makes it less stable.
When does an object topple over?
When it is tilted far enough that the line of action of its weight (a vertical line down from the centre of gravity) falls outside its base.
Give one everyday example of a design choice made to improve stability.
Racing cars, ships and lorries are built with a low centre of gravity and wide base to reduce the risk of toppling.

Flashcards