4.12 Standardisation and inverse normal with unknown parameters
Studying this course? Keep your progress in one place.
Key facts
- and ; is the number of standard deviations from the mean.
- and .
- Compare values from different distributions using -values.
- If or is unknown, find from and solve .
- Two conditions give simultaneous equations for and . Convert upper tails to area to the left, and split symmetric conditions between two tails.
Standardising a normal variable
Subtract the mean and divide by the standard deviation to count standard deviations from the mean.
If , the -value of is the number of standard deviations lies from the mean. Positive means above the mean; negative means below. Rearranged, .
Standardising turns any normal variable into the standard normal , so . Check the sign: a value below the mean must give a negative .
- z-value
- Back to x
Worked example
. Find .
- 1
(not 16).
- 2
.
- 3
.
. What is the -value of ?
Comparing different distributions
Compare their -values: the larger is further above its own mean, relative to the spread.
-values let you compare performances measured on different scales. Amira scored 72 where and , so . Ben scored 81 where and , so .
Ben's mark is further above his group's mean, relative to the spread, so Ben did relatively better, even though both marks are above average.
To find an equivalent value in another distribution, keep the -value and use with the new parameters: .
Chen scores 55 where , . Dara scores 90 where , . Who did relatively better?
Unknown mean or standard deviation
Find from the standard normal, then solve for the unknown.
If or is unknown, you cannot use inverse normal on directly. Use inverse normal on (mean 0, sd 1) to find , then solve .
For an upper tail, convert first: means , so .
Sanity check: if only 20% are below 40, the mean must be above 40, and a lower tail gives a negative .
- 1
Write the probability
e.g.
- 2
Inverse normal on Z
gives z for the area to the left
- 3
Solve for the unknown
set and rearrange
Worked example
and . Find .
- 1
Area 0.2 to the left gives .
- 2
.
- 3
.
and . Which area do you use with inverse normal on ?
When both parameters are unknown
Two probability conditions give two equations in and ; solve them simultaneously.
Two probability conditions give simultaneous equations. Rearrange each to the form and solve by subtraction or with the GDC's equation solver.
For symmetric conditions about the mean, such as '3% differ from by more than ', put half the probability in each tail: , so .
Keep the -values to at least 4 decimal places; rounding early can change the third significant figure.
Worked example
5% of bolts are shorter than 49.2 mm and 10% are longer than 50.9 mm. Find and .
- 1
Lower tail: gives .
- 2
Upper tail: gives .
- 3
Write and .
- 4
Subtract: , so .
- 5
Substitute: .
Which pair of -values comes from and ?
Try an exam question
The random variable satisfies and . Find and .
[4 marks]
- [1] for and for .
- [1] and .
- [1]Subtracting: , so .
- [1].
That's the notes covered.
Carry on to the next subtopic.
Try a question
Find the -value of .
1 mark, marked against the mark scheme
Find the -value of .
1 mark, marked against the mark scheme